Answer / dharmendra kumar soni

As you are asking in that case this is an important that all
the pc should be same AD.Due to security reason all the pc
are separated 5 vlan with same ad domain.So this is final
solution that create 5 AD sites for each domain controller
on each vlan.

Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?

2 Answers   Siemens,

---

What does a router change in a packet when it forwards a packet to the next hop? * A: Destination physical address * B: Destination network address * C: Destination network address and the destination physical address

10 Answers   Microland,

---

Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link

4 Answers  

---

Which OSI layer handles physical address, network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network

2 Answers  

---

Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart

10 Answers  

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

What is a disadvantage of using a connection oriented protocal such as TCP? A. Packet acknowledgement may add overhead B. packets are not tagged with sequence numbers C. Loss or duplication of data packets is more likely to occur D. The application layer must assume responsibility for correct searchers of the data packets

1 Answers  

---

Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS

4 Answers  

---

Select the most correct statement regarding client port address assignment. The client port always matches the destination port. To access a web page the client uses the source port of 80 and the destination port is dynamically selected. When a client requests a web page the destination port is 80 by default and the source port for the client is dynamically selected. The client source port is 1024 to get web pages and 1055 when retrieving ftp files.

2 Answers  

---

i have donE B.E. IN COMPUTER SCIENCE AND THEN CCNA CERTIFICATOIN PLEASW LET ME KNOW IF ANY COMPANIES R HIRING FRESHERS PLEASE REPLY ON MY EMAIL ID karnailthakur@gmail.com

0 Answers   HCL, Wipro,

---

how will configure Nat

6 Answers   Spanco,

---

Does a bridge divides a network into smaller segments?

0 Answers  

---