Interested to Buy Any Domain ? << Click Here >> for more details...
Which OSI layer handles physical address, network topology?
A.) Presentation
B.) Physical
C.) Transport
D.) Application
E.) Data-Link
F.) Network
- 2 Answers
- 10471 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: E
Layer 2 the Data-Link layer performs this function.
| Is This Answer Correct ? | 17 Yes | 2 No |
Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?
What is the second best path name of eigrp?
In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port
How can you assign a vlan to a switch port?
IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
What is difference between fast ethernet and ethernet port?
13 Answers Bank of Baroda, Bank Of India,
You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.
What is the difference between half duplex and full duplex?
HI ALL , wanted to know if the rstp protocol.. rapid spanning tree protocol .. is imp to study with ccna's point of view or study of STP will be enough.. in some books rstp is nt given like todd lamle however in icnd2 its explained in detail.. please suggest asap .. thanks ..
Identify the 4 that are WAN technologies? A.) HDLC B.) FDDI C.) 802.5 D.) HSSI E.) SDLC F.) Frame Relay
Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP
let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.
CCNA 
