what are the differance between neutral and earthing?3 4303
how to select the rating of neutral ct with reference to transformer secondary current(in power transformer,stepdown tansformer,for example2000kva,11kv/415volt2 5065
What, in the construction of a transformer, controls KVA? For example 600/208/120 V transformer can be 10kVA or 45kVA!!! What do we change in the construction of a Transformer in order to change the rating but not the voltage.1 1327
how Local Breaker Backup relay working?1 3234
What is the function of a capaitor in 1-phase IM?1 2337
Is there any capacitor in 3-phase IM?why,xplain.2 1615
400Kv,can it be generated?why?2 3023
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.1093
How supply comes to your home?3 3661
when will be the iocl interview results ifaced the interview on september 8 th
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
what is ps impedance test
thyristor controlled APFC panel design parameter?
wht is embedded systems? what is new inthis field?
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
Explain the operation carried out in thermal power stations?
define as synchronous generator
why we use circuit breakers for switching instead of normal switching device?
Why does the adjacent zone of protection overlap?
what causes contact chatter when there is no demand on the air conditioning unit?
can any tell me why slope 40% and 80% is calculated in differential protection?