Is there any type of starter for DC motor other than two point,Three point and Four point starters?
1 2125HI FRIENDS,MYSELF & MY GROUP OF FINAL YEAR ELECT ENGG. ARE MAKING A 50/3HZ,5HP,1000RPM,440V SALIENT POLE SYNCHRONOUS GENERATOR.COULD ANYONE OF U TELL ME WHAT COULD BE THE ADV. & DISADVANTAGES OF MAKING SUCH A LOW FREQN.GENERATOR/
2 4519what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
2 5512Post New Electrical Engineering Questions
please send me the L&T Emb. sys. placement papers and entire details of pattren
Why squirrel cage motor can only use with low starting loads ?
can i able to get bhel previous exam question paper?
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
Electrical Engineering
Do you need any help with FEWA Electrical Supervisor exams?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
Why neutral point is consider as zero potential?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
How much minimum insulation required between 11kv/3.3kv transformer windings?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
HI SIR, AM PREPARING FOR RRB FOR SECTION ENGINEER POST. PLZ SEND ME THE PREVIOUS QUESTION PAPERS AND HELP ME. I HAVE NO ENOUGH TIME MY EXAM DATE IS 22ND JUNE.... MY EMAIL ID IS nalla.amarnath@gmail.com