HAT IS THE EFFECT OF LOW POWER FACTOR ON THE GENERATING STATION?HOW WILL YOU IMPROVE THE LOW POWER FACTOR?
1 7601EXPLAIN THE FOLLWING: (1) BANDWIDTH (2) SELECTIVITY (3) RESONANT FREQUENCY (4) CURRENT MAGNIFICATION
1 3336Post New Electrical Engineering Questions
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
generally in LT and MV motors we are using 3.5Coresx16,25,35,50 etc cable for supply.although motors is earthed at two point and having all protection.then why we are using that 1/2 core for earthing the motors.while in HT cable we are using only 3core cable for motor supply.generally lt and mv motors are delta connected and ht motors having star connection.whethere it is having any relation with winding connection( star or delta).all motors i am talking about are dol only.can anybody solve my confusion.thanks...
What is mean by hot and cold loop testing? What is the difference between them?
how do you test tachos and servos
State the frequency for rc phase shift oscillator?
excitation limit of an excitor
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
Why we cant store an ac power. If we coo store in which device we can?
What is meant by time harmonics and space harmonics?
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
can the measured percentage error during calibration of single phase energy meter be negative?
star delta starter contorl circuit... drawing..
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?