What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
1869How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
1807How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
1860Multi-step core is used in transformer to: A) Increase the output B) Decrease the cost of core material C) Decrease the cost of copper D) Increase the efficiency
1 9274Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
1767i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
SCM,
1991I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
1734Post New Electrical Engineering Questions
WHY SEPARATELY EXCITED MACHINE NEEDS EXCITATION BY DC SUPPLY WHY NOT BY AC
How to setting the volume of RTCC panel AVR (11kv) controller
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
On what basis the the size of Lightning arrester for buildings are selected ?
What is the unit of magnetic flux density?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
Earth has zero potential then what would be the neutral potential ?
Why does amplifier gain reduce?
How you give clearance to a spare feeder.
what is the working principle of a DG Set, Alternator, & exiter
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
what is meant by class 1 E in electrical power supply?
How to use earthing on shipments.
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.