slump test report2 3939
strenth of brick7 3839
What is minimum tensile strength required for structural steel works ?2 4215
What is the Null Point of chimney in Power Plant2264
Dear Frds, How can i calculate the Steel for RCC Slab, Please provide one Example also, so that i can understand very well. Ex: Area: 1320.0 Sft.(44' X 30') Span: 15'(Default). Column Size: 9"X15"(6 No.s 12mm Rods) Please Provide Calculation Details. Thankyou. Satish
how to diffenentiate the fixed beam and simply supported beam in the execution while reading the drawing and how the reinforcement detail will be differ for the above.962
we have a crushing plant and our product is experiencing flakiness and elongation over limit for granite. what is the solution to this problem? how can it be avoided and what to do differently? It is not ok for batching plants856
How to calculate productivity of construction equipment like excavator, dozer, rock breaker, riper7 57888
What type of foundation preferred in sandy soil ?9 12749
While calculating the weight of the steel per running meter, the formula used is [(dxd)/162]. Why 162 is used in denominator & how it is derived?
Steel requirement in kg of 6" thk slab Total qty 32.64 m3 Beam / column qty 35.39 m3
If specific gravity of cement is less than 3.15 what is the cause?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
procedure for preliminary selection of size of column of 5 storey building
what is the procedure involved in preparing mix design of m15 grade as per IS-10262-1982
PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavement, width 4m what should be length of panel.
how to calculate the steel in 500yard
what is the steel difference between np-2 and np-3 pipes and weight also
can we find any technical issue if we are gong to change the dimensions of steel beams from one type to another type IE if there are any equievelant data base to find solution for problem of changeing sectios of beam from one type to another with the same cross sectional area.
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
what is difference between fluidity and workability also how palsticizer works
how to calculate the material from ratio of work PCC, RRM,POINTING, RCC
What is the outturn of Ceiling plastering
The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it