When we run the report j1ifr ( pending 4(5)a challan )this report can we convert in excel sheet.
1018Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
1131I have a 2000 grand Prix with the 3.8 liter engine and my alternator went out are there other alternators that can be used instead of buying the specific one needed.
695How to select Fuse Rating, Wire size in Passenger Car? Why we are considering Car as 12V system since alternator is one who supply power when car is in running state?
470The main advantage of a good clutch is a) Good torque transmission b) Rapid engagement c) Large size d) High inertia
624Hard shifting of gears would result when a) There is rapid engagement of gears b) There is less heat dissipation c) The clutch inertia is very high d) There is no clutch free pedal play
360Post New Automobile Engineering Questions
The main advantage of single plate clutch over cone clutch is a) Easier gear changing b) Less binding of contact surfaces c) Less pedal movement d) all of the above
The main advantage of a good clutch is a) Good torque transmission b) Rapid engagement c) Large size d) High inertia
How does the thermostat work?
What is Kirchhoff's Law ?
What do you understand by ductile-brittle transition temperature?
i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam
Describe the stress and strain curve of steel.
If a diesel engine is running at 2500 RPM, How much would be RPM of turbocharger?
where can i get the course for automobile engineering in delhi?
What are internal combustion engines?
Why black colour are used for tyres? is there anything related with heat conduction?
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
Why black colour are used for tyres?
In case of a constant mesh gear box, when the left dog clutch is slid to the left by means of the selector mechanism, a) Direct gear is obtained b) First gear is obtained c) Second gear is obtained d) Reverse gear is obtained
What do you mean by independent suspension?
