Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!

2077

Propeller shaft is used for the purpose of a) Transmitting the drive from the transmission to the bevel pinion of the final drive b) Transmitting the drive from the crankshaft to the road wheels c) Transmitting the drive from the transmission to the road wheels d) Transmitting the drive from the crankshaft to the bevel pinion of the final drive

1243

The friction plate is always mounted on a) flywheel b) Pressure plate c) Internally splined hub d) Clutch spring

1479

can we use servomotor for applying torque or load to the gear box drive shaft at various speeds for gear box testing purpose

2521

What do you understand by ductile-brittle transition temperature?

949

What is DTSI technology?

1179

What do you mean by independent suspension?

1003

What is the reason for emitting the white exhaust smoke during start of the vehicle? How will you prevent this?

1019

What is back compressor in engine?

1017

How can the fatigue life of a part can be improved by?

1031

difference bitween CPC & SQC

2573

Explain the concept of hit and miss governing in IC engines.

1130

Which conduct faster heat among steel, copper and brass?

1017

The main disadvantage of sliding mesh type of gear box is a) High noise level b) Low mechanical efficiency c) High skill required by the driver d) all of the above

1239

Classify Lathes.

980