Which of the following does not specify an application requirement that affects your network design? A. The number of users B. The peak hours that the applications are used C. The types of applications used D. Security risks

Which address is updated at each hop in the path in path switching?

Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.

What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay

What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer

OSPF supports priority routing for which TCP/IP feature? A. PA B. TCP C. IP D. SNA

Which of the following is not true in regards to route summarization? A. It increases the size of the routing table B. It increases the complexity of the network C. IP networks must be contiguous to be safely summarized D. Routing tables must have the capacity to support classless routing

What network design is becoming common when there is a central office with one or more remote locations? A. ISDN PRI at the central location and ISDN BRI at the remote locations. B. Using core routers at all sites C. Only using access routers D. Using a full mesh network

When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices

When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information

It is not necessary to build an entire network to prove your network design. A. True B. False

What is the second step when creating a prototype? A. Develop a test plan B. Review the customer requirements C. Investigate what the competition will be proposing D. Define how big the prototype will be

What are two services that DUAL (Diffusing Update Algorithm) performs for EIGRP? A. Provides loop-free operation throughout an entire route?s computation B. Simultaneous synchronization of routers involved in a topology change C. Updates the autonomous system number D. Allows advertised distances to use feasible distances

When characterizing a network, how many buffer misses should not be exceeded on a Cisco router per hour? A. 10 B. 25 C. 50 D. 100

When designing a flat switched network you can have: A. the same number of IP and IPX nodes without performance degradation B. more IP than IPX nodes on the same segment C. more IPX than IP nodes on the same segment D. more AppleTalk than IP nodes on the same segment