Which address is updated at each hop in the path in path
switching?
- 1 Answers
- 2614 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: Media Access Control (MAC)
At each hop, the Data Link layer or Media Access Control
(MAC) addresses change. On the other hand, Network layer
addresses stay the same from the source all the way through
to the destination.
| Is This Answer Correct ? | 0 Yes | 0 No |
What type of address is analyzed by a Layer 2 switch? A. network address B. MAC and network address C. Protocol type, MAC, and network address D. MAC address
Match the following routing techniques with the correct descriptions: A. Static Routing 1. Mandatory configuration B. Dynamic Routing 2. No route updates 3. Can better tolerate failures 4. Sends update when topology changes 5. Path is determined by the router 7. Traffic is reduced
You may receive a case study including Token Ring and Ethernet, so you may want to look at any constraints with cabling between Token Ring and Ethernet networks. Which statement describes the constraints imposed by the existing network? A. Replace all cabling B. Test all cabling C. Do not replace cabling D. Use microwave instead of cabling
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU
Which of the following three sets of IP addresses and subnet masks are private IP addresses? A. 10.0.0.0 255.0.0.0 B. 172.16.0.0 255.255.0.0 C. 172.16.0.0 255.240.0.0 D. 192.168.0.0 255.255.0.0
Which of the following three protocols replace SDLC? A. 802.2 B. HDLC C. QLLC D. X.25
Which of the following does not specify an application requirement that affects your network design? A. The number of users B. The peak hours that the applications are used C. The types of applications used D. Security risks
Match the following services with the correct descriptions: A. BRI 1. Provides two 64 Kbps B channels B. PRI 2. Provides 23 or 30 B channels 3. Provides one 16 Kbps D channel 4. Provides one 64 Kbps D channel 5. Provides a total bit rate of 2.048 Mbps in Europe and Australia 6. Provides a total bit rate of 144 Kbps 7. Provides a total bit rate of 1.544 Kbps in North America and Japan
A device has 2 synchronous ports, 16 asynchronous ports, and one ethernet port. What is this device most likely to be? A. CSU/DSU B. Access Server C. Multiplexer D. ISDN Terminal Adapter
SNMP agents are: A. Management devices B. NMS (Network Management Stations) C. network devices such as routers, switches, or hubs D. PDUs
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
CCNA 
