Interested to Buy Any Domain ? << Click Here >> for more details...
When doing an RFP (Request for Purchase) for a customer, at
what step do you reiterate your solution and the customer
requirements?
A. Design Requirements
B. Design Solution
C. Summary
D. Appendices
- 1 Answers
- 4197 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C
When doing an RFP (Request for Purchase) for a customer, you
reiterate your solution and the customer requirements at the
Summary step. See our ?CCDA Memorization Lists? under the
heading, ?Preparing a Design Document?
| Is This Answer Correct ? | 0 Yes | 0 No |
What are two differences between 10BaseT and 100BaseT? A. Speed B. Frame format C. Addressing D. Network diameter
You may receive a case study including Token Ring and Ethernet, so you may want to look at any constraints with cabling between Token Ring and Ethernet networks. Which statement describes the constraints imposed by the existing network? A. Replace all cabling B. Test all cabling C. Do not replace cabling D. Use microwave instead of cabling
What are three ASN.1 (Abstract Syntax Notation One) data types? A. data feeds B. name C. syntax D. encoding
Match the following routing techniques with the correct descriptions: A. Static Routing 1. Mandatory configuration B. Dynamic Routing 2. No route updates 3. Can better tolerate failures 4. Sends update when topology changes 5. Path is determined by the router 7. Traffic is reduced
Which two of the following describe ASN.1 (Abstract Syntax Notation One)? A. It is an abstract routing protocol that is not used very often. B. It is an OSI language for describing data types independent of particular computer structures and representation techniques. C. Consists of only one basic routing algorithm. D. Uses BER (Basic Encoding Rules).
Which condition does not create LAN media problems? A. Protocol doesn?t scale well B. Long wait for the token C. Excessive collisions D. Too many devices
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
What are three LAPB features supported by SDLC? A. Frame types B. Frame format C. Field functions D. ABM
What device initiates a session in an X.25 network? A. DTE B. DCE C. PSE D. PAD
Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network
What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer
When should you apply SAP filters to Netware service advertisement messages? A. When services are not required for a particular area or network B. Only after service advertisement messages have flooded the network C. Before any type of router convergence takes place D. When no change in network services has taken place for 40 minutes
CCNA 
