Answer / iliyas ahmed

IGRP - is Internet Gateway Routing Protocol.
And EIGRP is Advanced version of IGRP, i.e. Enhanced Internet Gateway Routing Protocol.

In which protocol supenetting is enable by default?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

4 Answers  

---

Which command listed below sets the banner message when someone connects to the router? A.) message # B.) banner # C.) login banner # D.) description # E.) login description # F.) banner motd #

2 Answers  

---

Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3

2 Answers  

---

How do areas benefit a link state inter network?

0 Answers  

---

---

Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation

2 Answers  

---

What will be the prefix length of 224 in vlsm?

0 Answers  

---

Identify 3 LAN technologies? A.) FDDI B.) HDLC C.) HSSI D.) X.25 E.) 802.3 F.) 802.5

2 Answers  

---

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

1 Answers  

---

what is difference between hub and switch?

7 Answers   IBM,

---

Which protocol works only on cisco routers?

0 Answers  

---

Which layer is responsible for synchronizing sending and receiving applications? A.) Presentation B.) Session C.) Transport D.) Application E.) Network

1 Answers  

---