In my job I have 6 steps. Step01,02,03...step06. after executing step02 i want to skip step03 and want to execute step04. and once step04 is done then I want to go back and execute step03. once step03 is completed I want execute step05, 06 and so on... can any one tell me how do i do that???

Perot Systems,

I have 20 steps in a job... step01, 02....step17...step20. For some reason I want to execute step17 only if the return code for all the previous steps are less than or equal to 4. otherwise if return code for any of the previous 16 steps is greater than 4, then step17 should be bypassed. How do I do that ?? how and in which step should i formulate COND parameter

I have PS flat file with 14 records. I want to read from 4th to 9th record and want to write those 6 records (4th record to 9th record) to another PS file (output file). there is no key defined in the input file. I just want read a certain Consecutive records. can any one please give me the procedure division Coding for this. I have coded the below coding but the READ-PARA is performing only 1 time even though I have 14 records in my input file (i.e FILE-1): PROCEDURE DIVISION. A000-SECTION. MOVE 0 TO I. OPEN INPUT FILE-1. IF CHECK-KEY1 > 0 DISPLAY "OPEN ERROR FOR FILE-1, CODE IS:" CHECK-KEY1 END-IF. OPEN EXTEND NEWFILE-1 IF CHECK-KEY3 > 0 DISPLAY "OPEN ERROR FOR NEWFILE-1 COD IS" CHECK-KEY3 END-IF. PERFORM READ-PARA THRU EXIT-PARA UNTIL EOF-REC = 'YES'. DISPLAY " FINALLY OUT OF LOOP" CLOSE FILE-1 CLOSE NEWFILE-1 STOP RUN. READ-PARA. ADD 1 TO I READ FILE-1 AT END MOVE 'YES' TO EOF-REC IF I > 3 AND < 10 PERFORM WRITE-PARA ELSE DISPLAY "NOT IN RANGE" END-IF. EXIT-PARA. EXIT. WRITE-PARA. WRITE NEW-REC FROM FILE1-REC.

IBM,

Can we install 2 different versions of Db2 on same mainframe?

01 NAME1 PIC X(13) VALUE "COBOL PROGRAMMING". 01 NAME2 PIC X(13). now I want to display the value of NAME1 in reverse order i.e value should be displayed as "GNIMMARGORP LOBOC" HOW can I do that ??? please let me know if any one knows it.

FirstApex, NIIT,

Hello friends, i am new to AS/400. Can any one help me in AS/400 i meant say can you send me some FAQS and interview questions.

HanceInc, IBM,

What is the benefit of using Externally Described files over Internally Described?

IBM, Patni,

What is the difference between a Physical File & a Logical?

Accenture, ACS, IBM,

What is SDA used for?

What are Triggers?

Ordain Solutions, Seabus Solutions,

Where would you use Override Data Base File?

What controls which printer a report goes to?

Wipro,

period is missing in the cobol program which error we getting

TCS, Tesco,

What is Natural?

TCS,

I have two sequential files, FILE-1 and FILE-2. FILE-1 contains 2 columns(A,B) and FILE-2 contains 3 columns (C,D,E).I want an output file, FILE-3 which has all five columns with duplicates eliminated from column A.