when i went to convergys then i was asked to these question? only for technical post 1. give me your introduction 2. what is ping, ms config, safe mode, last known configuration, system restore, backup, ip address and what is command prompt.....1091
difference between structure and union.2 5011
How do you make derived class as an abstract class?1 3100
What do mean by Computerization of accounts
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
general diesel engine we are using 15w 40 oil unfortunatley our oiller mis used the oil hudralic oil refilled when he doing the service which kind proplem coming in future?
what is the difference between changer, converter and transformer?
Explain Difference between congestion control and QoS(or Quality of service)
how can we bind the multiplication of two drop down lists?
important questions about sip and ims protocols
write a test case for telephone billing ?
Hi to all..Now am working at one company as Software tester..I have selected for Accenture via one consultancy.. They have told that joining date will be on 19 th july..But now they are postponed joining date..whether i can trust that or not?Can u plz tell??plzz..whether i can put my paper to releive or not? CAn u telll?
How doe's the storm make in the sky.
What is the difference between a value table and a check table?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Questions on the projects listed on the Resume.
how to register dll in COM / COM+ application
Hi Friends, I want to know the best institute in hyderabad which is giving training in 'SAP Testing' and who is the best faculty. Regards, Imtiyaz..