Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
2018why petrol engine gives more power than diesel engine eventhough diesel engine has high compression ratio?
11 31910Post New TATA Mechanical Engineering Interview Questions
What is the normal table capacity for gathering data?
How to include a javascript menu through a site?
What are the allotropes of iron and carbon?
What do you understand by constants in angular?
What will you do if a portion of load bearing wall collapses under your supervision?
What are the different types of research possible?
What is the difference between microsoft edge and internet explorer?
what are the accounts created in sap mm?
what is the series parallel connection of capacitors? and how can we use these application in three phase motors for controlling torque?
How do you recover a corrupted hard drive?
What are the limitations of AI in cybersecurity?
Can explain about the validations and in your project where did u used the validations?
What is db driver?
what is c4x light weight cement blocks
what is the undefined bits in flag registers of 8085 microprocessor?