How decided 10 ppm standard solution in Swab, rinse method.?
- 2 Answers
- 7921 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / venkat narayana
As per your standard test procedure,you decide yours specification, batch to batch (i.e same product)product change over 100 ppm standard we prepared and batch to another batch(i.e. product change) we have prepared 10 ppm standard
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / kalyan
First we have to prepare 10 ppm standard solution with the respective solvent then we have to determine the abosorbance of that std by using uv after that we have to find the rinsed or swab sample absorbance by usig uv then we can calculate the result using the formula:(sample absorbance/standard absorbance)*10 then we will get the result in ppm
| Is This Answer Correct ? | 7 Yes | 9 No |
what are the important specifications for a Column ?
why sucrose is used for polarimeter calibration
what is difference of uv and pda
13 Answers Akums, MSN, MSN Pharma, Shilpa Medicare,
my name is santhosh i cmpleted b.pharmacy in 2009 then i went to uk in 2010 to pg diploma business management. after i came back to india.. recently again apply to uk for pharmaceutical analysis. they refused my visa you failed to explain y u r change subject. so plz ineed answer for y change the cource
I want analyze my compound at 325 nm so which standard shall i use to calibrate my HPLC system? How i can assure my hplc detector is suitable or not?
why require to add enzymes in capsules dissolution only? is it require to tablet also?
What is split ratio in Gc? Splitless? how requirr to select?
what is Hilic chromatography?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
control of resolution in calibration of IR
What is column in chromatography?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
Organic Chemistry 
