Interested to Buy Any Domain ? << Click Here >> for more details...
Why PH range from 0to14.
- 2 Answers
- 14415 Views
- College School Exams Tests, Reddy Labs, Wings Customer Care, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / sandip ankolia
Because of condivity of water is 1.0 x 10 -14
if water dissociation is H+ and OH-
H2O = 1.0 x 10-14
log (H2O) = log (1.0 x 10-14)
PH = 14
| Is This Answer Correct ? | 27 Yes | 2 No |
Answer / usha (gvk)
*** The equation for finding the pH of a solution is –log
([H+]). That is, the negative log of the molarity of the
hydrogen ions released by the compound in solution. Almost
no chemicals can release hydrogen ions with a molarity
greater than 1 or less than 10^-14. However, there are some
rare cases where the pH of a solution is not between 0 and
14. For example, 10 molarity hydrochloric acid (there are
ten moles of hydrochloric acid for every liter of water.),
has a pH of -1 (-log (10) =-1). But these are so rare in
occurrence.
| Is This Answer Correct ? | 2 Yes | 0 No |
why we wre doing linearity siudiec in hplc method validation
what is the difference b/w water content & moisture content
What is use of LOD and LOQ in validtion and give range and in calculation why we use 3.3* LOD here why we use 3.3
2 Answers Dr Reddys, IPCA, Reddy Labs,
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
how to qualify the impurity?
Related substance method equivalency on control sample or spiked sample?
why plane of polarized light rotated by opticaly active compunds?
why KF factor is between 4.5 to 7.5 mg/ml ? why ? why sometime pyridine is used in analysis like in raw material solvent like acetone etc?
11 Answers Aurobindo, GVK, Sohan Healthcare,
1)why use benzophenon,uracil in hplc calibration. 2)why use sucrose in polarimeter calibration. 3)what is S/N ratio, noise and drift in hplc 4)how we can find lod and loq in method validation
for which type of applications gas chromatography is used?
In performance Check of GC Why Hexadecane Peak is Considered
0 Answers Asian Paints, MSN Pharma,
What is linearity in hplc and how to calibration
Organic Chemistry 
