Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following are used by routers to learn routes
to be added to the routing table?
Ping and Traceroute
MAC address resolution
Acknowledgments and Sequence Numbers
Routing updates and static routes
- 1 Answers
- 3890 Views
- I also Faced
- E-Mail Answers
Answer / jitendera kumar sinha
Routing updates and static routes
| Is This Answer Correct ? | 4 Yes | 0 No |
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
Which two steps are part of the process of creating Frame Relay subinterfaces on a point to point connection? (Choose two) A. configure the router to forward all broadcast packets B. remove any network address assigned to the physical interface C. configure the local data link connection identifier (DICI) for the subinterfaces D. cartoon the total committed information rate (CIP) available among the subinterfaces
Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells
Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery
Which command do you use to set the Secret password to 'roundwood'? A.) enable login roundwood B.) enable password roundwood C.) enable privilege roundwood D.) enable secret= roundwood E.) enable secret login roundwood F.) enable secret roundwood
Explain what is route poisoning?
What is hsrp?
What purpose does aging serve in a link state protocol?
Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099
What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router
Explain which layer are called upper layer?
Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet
CCNA 
