Interested to Buy Any Domain ? << Click Here >> for more details...
Which two does 100BaseT use?
A.) CSMA/CD
B.) IEEE 802.5
C.) 802.3u
D.) Switching with 53-byte cells
- 1 Answers
- 4020 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A C
100BaseT - 100BaseT uses two-pair Category 5 UTP cable with
an RJ45
connector and the same pin out as in 10BaseT. 100BaseT
supports full
duplex operation. 100BaseT is limited to 100 meters distance.
| Is This Answer Correct ? | 0 Yes | 0 No |
Which command line statement determines the number of seconds a dialup connection can wait without any traffic before the router hangs up? A.) dialler max-time B.) dialler timeout C.) dialer idle-timeout D.) dialer hang-up E.) disconnect-timer
Which protocol will send a message to routers if a network outage or congestion occurs? A.) ARP B.) TCP C.) IP D.) ICMP
In which ios version 182 people can access router through telenet?
Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)
How to find Router Serial interface MAC address?
You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp
Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.
frends i am suffring from newfolder.exe virus in my server 2000 win how i have to remove it plz help me Jitendera sinha
What is the command use to add a banner to a cisco router configuration?
why we give clock rate to DCE and not to DTE what is the difference in the two.
Which command allows a user to see previous commands? A.) show command B.) CTRL-P C.) show history D.) CTRL-U E.) Up Arrow F.) SHIFT-CTRL-6
2500 Value in which type of access list?
CCNA 
