1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Describe End to End network services: (Choose all that apply)

A.) Best Route selection

B.) Accomplished Segment by Segment, each segment is autonomous

C.) Flow Control & Data Integrity

D.) Best efforts packet delivery

Question Posted / guest


Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Acc..

Answer / guest

Answer: B C

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

How many fillers we can put in one ip of ipv6?

1 Answers  

Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map

1 Answers  

Which router component stores routing tables APP cache and packet buffers? A. ROM B. RAM C. AVRAM D. Flash memory

3 Answers  

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

Which device works at the Network Layer of the OSI model? Router Switch Bridge Hub

5 Answers   CET, IBM,

Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  

What is the icmp protocol?

1 Answers  

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

What is switch priority & why it is used????

5 Answers   ADP,

What is encapsulation and de-encapsulation?

1 Answers  

Which OSI layer end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation

3 Answers  

For more CCNA Interview Questions Click Here
Categories