1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Layer 1 and Layer 2 devices must forward a broadcast.
Which of the following devices fall into this category?
Gateway
Switch
Router
All of the above.

Question Posted / samham


Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into th..

Answer / jitendera kumar sinha

Switch

Is This Answer Correct ?    8 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify 3 characteristics regarding IP access-lists? A.) Can be configured as a standard access-list B.) Can be run from another router running IP C.) Can be configured as a named access-list D.) Are the same as IPX access-lists E.) Can be configured as an extended access-list

1 Answers  

A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?

15 Answers   TCS, Wipro,

What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet

1 Answers  

HIGH MY ALL FRIENDS. CURRENTLY I AM WORKING DESKTOP SUPPORT ENGINEER IN mahindra & mahindra lTD.I AM CERTIFIED IN CCNA SINCE 28 DEC 2009.BUT I HAVE NOT RECEIVED CCNA CERTIFICATE. PLEASE HELP ME ..HOW RECEIVE THE CCNA CERTIFICATE.IF ANY INFORMATION IS AVAILABLE PLS SEND INFORMATION TO MY GMAIL ID.MY ID---- ngawde.cisco@gmail.com ngawde@yahoo.com

1 Answers   MAHINDRA,

What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21

1 Answers  

What is the default bandwidth size of t1 routers?

1 Answers  

Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP

1 Answers   Wipro,

You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.

2 Answers  

Which of the following is a valid extended IP access-list? A.) router(config)# access-list 101 permit tcp host 172.16.30.0 any eq 21 log B.) router# access-list 101 permit tcp host 172.16.30.0 any eq 21 log C.) router(config)# access-list 101 permit any any 172.16.30.0 D.) router(config)# access-list 101 permit ip host 172.16.30.0 any eq 21 log

2 Answers  

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch

3 Answers  

Utilizing RIP, what is the limit when it comes to the number of hops?

1 Answers  

On which interface we always apply access-list?

1 Answers  

For more CCNA Interview Questions Click Here
Categories