Answer / jitendera sinha

Low Overhead
Not reliable ( is this advantage i don't think so ?)

Answer / deepak

Low Overhead

Answer / saroja hariharan

yes Jitendera ,its also one type of advantage only,if u want to send a small amount of packets r msgs in an urgent means u can use udp,bcz udp take low overhead with high speed....

Answer / n.s.k.reddy

Reliable

What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

1 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

---

What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates

1 Answers  

---

Identify the 3 major functions at layer 3 of the OSI model? A.) Forwarding process B.) Logical addressing C.) End-to-end connnections D.) Path selection E.) MAC address examination F.) Network monitoring

2 Answers  

---

How do you view the routers current processor utilization? A.) show version B.) show processes cpu C.) show running-config D.) show startup-config E.) show cpu F.) show utilization

3 Answers   Cisco,

---

Which protocol carries messages such as destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, Redirect, Echo, Echo Reply, Timestamp, Information Request, Information Reply, Address Request, and Address Reply? A. ICMP B. UDP C. TCP D. TFTP E. FTP

2 Answers   TCP,

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

2 Answers  

---

How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology........ Hi friends Thanks for posting the answer of above given questions i agree with all of you that BPDU is the Protocol that are used to determine this is clear to me.. But I want to Know the Process like Why it Blocked the port Fa0/1 Insted of Fa0/2 waiting for Answer Posting .... Thanks in Advance

5 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

How signalling can be explained in D channel of ISDN?

1 Answers   Tulip,

---

How much internal and external ad of eigrp protocol?

0 Answers  

---

what is full form of rst,smtps & http?

2 Answers   HCL,

---