1 what is the number of telnet session in the cisco router
a 1
b 2
c 3
d 4
e 5
Answers were Sorted based on User's Feedback
Answer / mahesh
option e: is write 0-4 virtual lines count 0 line as 1 soon
and one more thing its for old switch r routers, new one
has 16 lines ie. 0-15 and can be more depend on series of
router or switch...
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / jitendera kuaar sinha
yeah i was also confused in that question. what is that?
sudenly one thought comec in mind that
router(config)#line vty 0 4
so to counting 0 4 i am mark the answer 5 that is e
so i am little bit confused that is that wright answer.
if any one know plz tell
| Is This Answer Correct ? | 1 Yes | 0 No |
As far as i know its entirely depend on the number of virtual lines that the router IOS supports and number of lines are configured with password. At first this question is incomplete because telnet sessions work at layer 7 means purely software that means telnet uses the virtual terminal line. virtual means software Cisco IOS 12.2 supports 16 simultaneous and previous IOS supports max of 5 lines
| Is This Answer Correct ? | 0 Yes | 0 No |
Which two statements about a bridge are true? (Choose two) A. A bridge floods multicasts B. A bridge floods broadcasts C. A bridge does not flood multicasts D. A bridge does not flood broadcasts
Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network
How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?
Does a bridge divide a network into smaller segments?
in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks
Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces
Classful routing protocols do not include subnet masks in their routing updates. Which of the following routing protocols are considered classful? A.) EIGRP B.) OSPF C.) TCP D.) IGRP E.) RIP F.) IP
What are the things that can be accessed in a CISCO router’s identifying information?
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains
how many vlan can be configured on a single switch
When the router runs out of buffer space, this is called ________. A. Source Quench B. Redirect C. Information Request D. Low Memory