Answer / juhi

AT THIS POINT WE MUST CLARIFY TWO TWRMS IMP TO COMPUTER
NETWORKING TO COMPUTER NETWORKING DTE & DCE THERE ARE BASIC
FOR BASIC FUNCTIONAL UNITS INVOLVE IN THE COMMUNICATION OF
DATA.DTE AND DCE ON ONE END AND A DCE AND DTE ON THE OTHER
END.DTE GENERATES THE DATA AND PASSES THEM ALONGWITH ANY
NECESSARY CONTROL CHARACTERS TO A DCE.THE DCE CONVERTS A
SINGLE TO A FORMAT APPROPRIATE TO THE TRANSMISSION MEDIUM
AND INTRODUCE IT ONTO THE NETWORK LINK WHEN THE SINGLE
ARRIVES AT THE RECEIVING ENDTHIS PROCESS IS REVERSED.

Answer / karthik

DTE means data terminal equipment.DCE means data circuit
terminal equipment.dte is hub,swicth,repeater&then dce is
pc,router.cross cable is use on DTE to DTE& DCE to
DCE.striaght cable cable is use on dte to dce.then simple
formulee is cross cable
1)white orange t1 white green
2)orange t2 blue
3)white green r1 white orange
4)green green
5)white blue white blue
6)blue r2 orange
7)white browen white browen
8)browen browen

this is the connection of cross cable.
the straight is connected through same cable in double
side.This is my answer

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

Explain the difference between bus topology and hub?

0 Answers  

---

Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts

1 Answers  

---

Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

what is frame relay.and how it is different from isdn

1 Answers   HCL,

---

Which OSI Reference Layer controls end-to-end (host to host) communication? A.) Transport B.) Physical C.) Datalink D.) Network E.) Session

1 Answers  

---

Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com

0 Answers   HCL, Wipro,

---

State the difference between dynamic IP and static IP addressing?

0 Answers  

---

Define the virtual path?

0 Answers  

---

Explain what is the default behavior of access-list?

0 Answers  

---

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

2 Answers  

---