Interested to Buy Any Domain ? << Click Here >> for more details...
from last ten days i watched that no any new questions are
placed in ccna catogarey.so plz place the questions it is
very use full to beginers like us
- 2 Answers
- 4005 Views
- HCL, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / ahmedabad
stands for ccna ?
what is use brouter?
how can change the router mac adderess?
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / akbar ali
Basically ...
The Source and Destination IP address is not going to change. Host 1 IP address will stay as being the source IP and the Host 2 IP address will stay the destination IP address. Those two are not going to change.
For the MAC address it is going to change each time it goes from one hope to another. (Except switches... they don't change anything)
Frame leaving HOST 1 is going to have a source MAC of Host 1 and a destination MAC of Router 1.
Router 1 is going to strip that info off and then will make the source MAC address of Router1's exiting interface, and making Router2's interface as the destination MAC address.
Then the same will happen... Router2 is going to change the source/destination info to the source MAC being the Router2 interface that it is going out, and the destination will be Host2's MAC address.
In a nutshell that is about what happens.
Hopefully that makes some sort of sense.
Good Luck,
| Is This Answer Correct ? | 0 Yes | 0 No |
Explain the term 'unicast'.
How many networks route update does a router recieves in RIP at once ?
Novell IPX network addresses have two conferrable parts. The network administrator specifies the IPX network number. How is the node number determined? A. It is the serial number of the given device B. It is assigned as a lease by Novell DHCP C. It is also set by the network administrator D. It is usually the MAC address of one Interface E. It is downloaded by Netware Core Protocol (NCP)
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
What is the minimum and maximum request timer?
Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS
7. What is an advantage to using switches in your network? A. Addressing of hosts by DHCP B. Ease of administration C. Stops broadcast storms D. Works like a repeater
What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16
Which protocol will let neighbor routers know if your internetwork experienced congestion on a serial port? A.) BootP B.) IP C.) ICMP D.) ARP E.) FTP F.) RARP
How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64
What are 10base5 ethernet lans?
CCNA 
