Interested to Buy Any Domain ? << Click Here >> for more details...
Given the IPX address 4a.0002.1111.a999, what is the network ID
and what is the node ID?
A.) net 4a host 0002.1111.a999
B.) net a999 node 0002.1111
C.) net 0002.1111.a999 node 4a
D.) net 0002.1111 node a999
- 1 Answers
- 3873 Views
- I also Faced
- E-Mail Answers
Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0
What is hold down time formula of ospf?
Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub
What are the different memories that are used in a cisco router?
What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.
Which EXEC command displays system hardwarde configuration information software version and the names and sources of configuration files and boot images on a router? A. show boot B. show flash C. show config D. show version
Which addresses are INCORRECTLY paired with their class? A. 128 to 191, Class B B. 192 to 223 Class B C. 128 to 191, Class C D. 192 to 223, Class C
Name which protocols are link states?
If there is only 2 host in bus topology is that possible collision accord?
The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111
On Cisco catalyst 5000 how would you set the second port on the controller in the first slot to full duplex? A.) Set port duplex 1/1 full B.) Set port duplex 1/2 full C.) Set port duplex 0/1 full D.) Set port duplex 0/2 full
what do you mean by port triggering?
CCNA 
