The Cisco IOS is stored where?

A.) ROM

B.) CD

C.) Flash

D.) NVRAM



The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM..

Answer / guest

Answer: C

By default the Cisco IOS is stored in flash.

Is This Answer Correct ?    4 Yes 1 No

Post New Answer

More CCNA Interview Questions

What is HDLC?

1 Answers  


How we put NIC in promiscuous mode when using MS windows, can any one tell me in detail

1 Answers   Cisco, IBM,


What is difference between static and dynamic routing?

1 Answers  


What is the standard ISDN term for a native ISDN modem? A.) ET B.) LE C.) TE2 D.) TE3 E.) TA

1 Answers  


Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network

2 Answers  


Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)

2 Answers  


Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  


A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management

1 Answers  


Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)

1 Answers  


If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through

2 Answers  


Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

3 Answers  


Which Distance Vector characteristic can help to speed up convergence? A.) Triggered Updates. B.) Split Horizon. C.) Poison Reverse. D.) Hold Down timers. E.) Inverse ARP.

1 Answers  


Categories