What is the default size of a standard ping on a Cisco router?
* A: 100 bytes
* B: 32 bytes
* C: 10 bytes
* D: 16 bytes
- 2 Answers
- 8510 Views
- CMS, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jitendera sinha
answer is 100 bytes that is A
go to router#
router#ping ip address
out put is that
pinging.........
100 bytes 5 sec....... (100%)
| Is This Answer Correct ? | 19 Yes | 4 No |
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
Operation of two PC connecting with brand new switches. (they expecting step by step arp ,broadcast,MAC table, RARP operation)
What is trigger rip and from which ios version it starts?
What is the diiffernce between windows xp & windows 2000?
6 Answers TCS, Trimax, Trymax, VigaTech,
what is router?
What are the possible ways of data transmission in ccna?
Can you explain in a generic manner the packet of IPSec?
What is cam?
What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex
The Network layer works with which of the following: A.) Globules B.) Bits C.) Packets D.) Segments E.) Frames
What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Gandalf5 B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) SAP
When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop
CCNA 
