What are the possible ways of data transmission in ccna?
No Answer is Posted For this Question
Be the First to Post Answer
Identify 1 characteristic of RARP? A.) MAC to IP address translation B.) Connectionless delivery of packets C.) Can be used to initiate remote O/S load sequence D.) Generates error and control messages
Which of the following protocols are used for logical network addressing? A.) IP B.) TCP C.) ARP D.) ICMP E.) RARP F.) BootP
In stead of 0.0.0.0 wild card mask what you can write after ip?
Identify the 3 characteristics of IPX RIP? A.) Distance vector B.) Does not support multiple paths C.) 60 second updates D.) Default encapsulation is SAP E.) Uses ticks and hop count as a metric
For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix
What are 10base2, 10base5 and 10baset ethernet lans?
What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP
6. Which device can create smaller networks and stop broadcast storms by default? A. Repeater B. Bridge C. Router D. Gateway
What does the following series of commands accomplish? router igrp 71 network 10.0.0.0 router igrp 109 network 172.68.7.0 A. It isolates networks 10.0.0.0 and 172.68.7.0. B. It loads igrp for networks 109 and 71. C. It disables RIP. D. It disables all routing protocols.
What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router
What are packets?
Identify 3 methods not used to prevent routing loops? A.) Holddown timers B.) Sequence numbers C.) Triggered updates D.) Split horizon E.) Area hierarchies F.) Order of router startup