HI
THIS IS SHEKAR MY QUTION IS IF I HAD 10 YEARS DATA IN MY
SOURCE THEN I WANT TO LOAD ONLY LAST YEAR DATA HOW IT IS
POSSIBLE BY USING DATASTAGE7.5.
Answer / qwerty
First step:
Switch off CAPS LOCK.
Then try again
Is This Answer Correct ? | 1 Yes | 2 No |
1. How many nodes you are using project? 2. What is configuration file? 3. What is modules partition? How it is work in project? 4. What is Environment Variable? How it is use? 5. What is sequence? 6. How do you execute parallel jobs in projects? 7. If you run a job in job sequencer individually without any comments? 8. How many jobs did in your project? 9. How to schedule the job in Data stage 7.5 X2? 10. If you have 10 jobs in PX2, shall you run all jobs at a time? 11. I have 5 jobs (1-5), I connect with each other, but I want to run from 3-5 only how? 12. What is same partition? 13. If you have 40GB hard disk in I have 30GB data how I configure the nodes for partition? 14. Did you write any code for Data stage project? 15. Did you write any code for parallel job execution in your project? 16. Will you schedule all jobs at a time?
What is normalization in dbms?
How are exceptions handled in pl/sql? Give some of the internal exceptions name?
State at least four kinds of indexing?
Explain the advantages of rdbms?
what is s/w lifecycle?
What do you understand by cursor?
What are the different types of languages that are available in the dbms?
What are the different file extensions that are created by Oracle ?
Explain the term entity in dbms?
what is s/w lifecycle?
Explain what are service-specific middleware?