Answer / kapilasdhir

Layer 2 Device provides the connectivity within a single
Network ID. As for example
1. Switch
2. Bridge

Answer / nathan

Layer 2 Device provides the connectivity within a single
Network ID. The data's are forwading in the form of frames.

Eg:

Switches
Bridges

Answer / m haja bahurudeen

Layer 2 Device using mac address. this devices having CAM
table. every port no stored in cam table.
this device using LAN connection only.

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

1 Answers  

---

i want to ask one question that why u guys are not posting the questions is any thing wrong please post question for your and others including me knowledge

3 Answers  

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

2 Answers  

---

Which Cisco IOS command should you use to display the Novell IPX address assignments on a router? A. show ipx addresses B. show ipx interface C. show me the money D. ipx, network (number) E. display ipx addresses F. show ipx routing details

1 Answers  

---

What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

---

As a system administrator, you need to provide your routers with a Domain Name System (DNS) server. How many DNS servers can you specify with one command? A. 6 B. 1 C. 2 D. 4

1 Answers  

---

Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network

3 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

2 Answers  

---

Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?

2 Answers  

---

What are the possible ways of data exchange in ccna?

0 Answers  

---

Identify 3 LAN technologies? A.) FDDI B.) HDLC C.) HSSI D.) X.25 E.) 802.3 F.) 802.5

2 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers   Wipro,

---