GUY
i Have attended one interview for the data craft and they
are offering me L1 postion and i am working at l2 in cisco
so there is no way to get in the datacraft
i am posting here the question he asked to and i have tested
the interviewer and i come to know he was not having any
knowledge.
His questions are-:
1) what is Vlan
2) what is stp and what is difference between stp and RSTP
3) what is HSRP and Diffrence betwwen HSRP and GLBP
4) how to configure HSRP
5) Scenario Based question ( if we have two router and both
are connected and there are having redundancy means two
interface of the router r1 is connected to the two interface
of Router R2
(R1)-------------(R2
(R1)-------------(R2
Now he want to configure the router in such a Manner that if
one link down second link should come up.My answer was HSRP
and his is "F looting static routing was i wrong "i know F
looting Static routing is Theoretically possible but it is
not fusible in the scenario where you have multiple router
connected to the same router and if you have configured sub
interface i challenged him and he lost The Battle and he get
angary
5) what the eigrp and how it works
6) tables in eigrp
7) the information of feasible successor where it saved
now after answering these all he was very angry ( i can fill
the heat)
8) then he come to ospf Area type ( he was also not aware)
9) LSA type and its working ( he was also having confusion )
10) then is asked routing by rummer( Theroy)
11) hello and dead intervel of EIGRp (theory)
12) Selection cretaria for Eigrp slecting best path ( here
we have a long discussion on MTU and he lost the battle and
agree That MTU never comes in the accounts in this process)
13) what is ACL type of acl ( here he was aware of TWO type
Standard and extended i have told him 5 type( he again get
Angry)
We have 2hr of discussion and and he told me he will call me
latter but i know he never call
Answer / guest
Need to see how much dramatically the number of visitor
increased
Shame on Guys who are looking for answers only and do not
even try to provide answer... Thanks Jitendera For such good
and us-full question
| Is This Answer Correct ? | 2 Yes | 3 No |
Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup
Which OSI layer establishes, maintains and terminates sessions between applications? A.) Application B.) Physical C.) Data-Link D.) Presentation E.) Network F.) Session
Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub
How many ways are there to implement VPN architecture?
If you have configured IPX on a Serial interface, which command would display the IPX network and node address on the Serial 1 interface? A.) show interface B.) show ipx s1 C.) show interface s1 D.) show ipx int serial 1 E.) show ipx int brief
In eigrp metric parameters which 2 options are enable by default?
what is vlan
Which two types of route table entries are used by a Layer 3 router to determine the appropriate path to destination? (Choose two) A. static route entry B. default route entry C. Dynamic route entry D. temporary route entry E. permanent route entry
Which layer is responsible for synchronizing sending and receiving applications? A.) Presentation B.) Session C.) Transport D.) Application E.) Network
MIDI and MPEG are examples of what layer of the OSI seven layer model? A.) Session B.) Network C.) Datalink D.) Transport E.) Application F.) Presentation
Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE
Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation