Classful routing protocols do not include subnet masks in their routing updates. Which of the following routing protocols are considered classful? A.) EIGRP B.) OSPF C.) TCP D.) IGRP E.) RIP F.) IP

2 Answers  

---

Which command verifies encapsulation as well as Layer 1 and Layer 2 statistics on a router configured for Frame Relay? A. show ip B. show interface C. show statistics D. show frame-relay

1 Answers  

---

what is frame relay.and how it is different from isdn

1 Answers   HCL,

---

Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only 4 encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.2 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encapsulation must be configured unless the connecting routers are both Cisco

1 Answers  

---

hi friends i have some problem regarding technical round ahr round plz tell me what should the right answer technical questions 1 what is brouter 2 what is the menaing of 10 base2, 10 base 5 and 10baset 3 what is diffrence between bit rate and baud rate. and this question was tooooooooooo much difficult to me that hr said to me that rank me after the taking the all short of interview

5 Answers  

---

what is difference between packet switching and circuit swtching

0 Answers   ASD Lab,

---

what are layer hierarchy of cisco

1 Answers  

---

Which OSI layer end to end communication, segmentation and re-assembly? A.) Network B.) Transport C.) Physical D.) Application E.) Data-Link F.) Presentation

3 Answers  

---

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

1 Answers  

---

which layer is responsible for flow control with sliding windows and reliability with sequence number and acknowledgement? A)Transport. B)Application C) Internet D)Network Interface

8 Answers   DOEACC,

---

How IEEE Calculate the Cost of Link (ex.. 10mbps is having Cost 100) Is there any formula or any test to calculate it.

2 Answers   IBM,

---