Which of the following can reply to a Novell Get Nearest Server
(GNS) request?
A.) Local Novell server
B.) Remote Novell Printer
C.) Cisco router
D.) Novell client
Answer / guest
Answer: A C
Cisco routers can act like Novell servers to an extent. They
can answer
Get Nearest Server request by clients. Of course, both Local
and Remote
Novell servers can reply to the GNS request. As with Novell
servers,
Cisco routers can be configured to either reply, or not
reply to GNS
request by clients. Since each Novell server and Cisco
router builds a
dynamic table of resources, they can reply to a clients
request for the
available resources closest to them.
Is This Answer Correct ? | 3 Yes | 0 No |
What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
What are the different memories that are used in a cisco router?
How much hold down time of eigrep protocol?
Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'
WHY DO WE USE the command interface Vlan 1 ip adress x.x.x.x sub mask what does it do .. what does it create.. i know when we create it we can remotely telnet inti a router=switch. but what is the diff bwt vlan and intface vlan. ... vlan 1 bieng a native vlan remains there eve if i dont gv switch an ip address .. lease suggest.
Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector
Which type of Ethernet framing is used for TCP/IP and DECnet? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config
Which statement is true when a broadcast is sent in an Ethernet/802.3 ITAN? A. The ip shored used is 255.255.255.0 B. The IP address used is 255.255.255.255 C. The MAC address used is 00 00 00 00 00 00 D. The MAC address used is FF FF FF FF FF FF
Can you explain CHAP?
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
What are the possible ways of data transmission in ccna?