Tell me when we use extended access-list?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer



More CCNA Interview Questions

The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions

1 Answers  


What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards

1 Answers  


can anyone tell me which r the companies hiring freshers ( ccna ) in mumbai

1 Answers   HCL,


Explain what is the size of hello packets in eigrep protocol?

0 Answers  


What does data packets consist of?

0 Answers  






What do you understand by redundancy?

0 Answers  


Port selection is done at which layer of OSI reference model?????

4 Answers  


When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

4 Answers  


Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  


UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link

1 Answers  


How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology

7 Answers   Tech Mahindra, Wipro,


Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  


Categories