Interested to Buy Any Domain ? << Click Here >> for more details...
Which statement is true regarding full duplex?
A.) Allows for transmission and receiving of data simultaneously
B.) Only works in a multipoint configuration
C.) Does not affect the bandwidth
D.) Allows for transmission and receiving of data but not at
the same time
- 2 Answers
- 5832 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
full duplex means it allows two way communication.that
means it can send and receive datas.
| Is This Answer Correct ? | 1 Yes | 0 No |
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC
What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000
What is the most common layer 2 device? A. Hub B. Bridge C. Switch D. Router
Which of the following is a valid TCP/IP socket for an Email connection? 101.34.2.125:25 00-00-03-1B-CA-6F:143 202.167.23.101:21 60.4:110
Can 2 different VTP Domain Communicate. if yes then How.
Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection oriented protocol that acknowledges receipt of data packets and is considered reliable
You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.
What is the syntax of ipv4?
Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes
Which can be true regarding VLANs? A.) They are created by location B.) They are created by function C.) They are created by department D.) They are created by group
Which classes are assignable?
CCNA 
