Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

4 Answers  

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

1 Answers  

---

What are four ways that Fast Ethernet compares to 10BaseT Ethernet? (Choose four) A. Fast Ethernet uses the same Maximum Transmission Unit (MTU) B. Fast Ethernet is based on an extension to the IEEE 802.3 specification C. Fast Ethernet uses the same Media Access Control (MAC) mechanisms D. Fast Ethernet preserves the frame format that is used by 10BaseT Ethernet E. Fast Ethernet errors a speed increase one hundred times that of the 10BaseT Ethernet

1 Answers  

---

A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management

1 Answers  

---

Which command can verify only Network layer connectivity between 2 hosts? A.) ping B.) e-mail C.) plp D.) arp E.) telnet

4 Answers  

---

How convergence happen in ospf?

3 Answers   TCS,

---

What is an advantage of local area network (LAN) segmentation? A. smaller collision domains B. elimination of broadcasts C. decreased cost of implementation D. larger number of users within the same domain

3 Answers   Cisco,

---

Explain what is the size of hello packets in eigrep protocol?

0 Answers  

---

What route entry will be assigned to dead or invalid route in case of RIP?

0 Answers  

---

Identify the purpose of the TCP 3 step handshake? A.) Setup a un-reliable connection B.) Initialize routing tables C.) Synchronize sequence numbers between hosts D.) Connection tear down process

1 Answers  

---

Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi

1 Answers  

---

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A

2 Answers  

---