Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port

1 Answers  

---

if 10 pc's connected from internet, in 8 pc's internet is correctly run but in other 2 pc's they can not access internet,what's the problem?

9 Answers   Fibcom, TATA,

---

Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport

2 Answers  

---

Which command we give if router ios stucked?

0 Answers  

---

When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

4 Answers  

---

What causes a triggered update to reset the router hold-down timer?

0 Answers  

---

If line up, but protocol down which layer should be troubleshot?

0 Answers  

---

Which company mange ip's?

0 Answers  

---

What is a network subnet?

0 Answers  

---

Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0

2 Answers  

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---