Which layer allows multiple Ethernet devices to uniquely identify one another on the Datalink layer? A.) Transport B.) Session C.) Network D.) Datalink - MAC Sublayer E.) Datalink - LLC Sublayer

3 Answers  

---

What is segmentation and fragmentation?

0 Answers  

---

How many maximum paths you can give on latest ios in rip?

0 Answers  

---

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

Tell me which protocol works only on cisco routers?

0 Answers  

---

A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?

2 Answers   Satyam,

---

Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP

1 Answers  

---

What are the different memories that are used in a cisco router?

0 Answers  

---

I have one problem in my network my windows xp pc in workgroup there r 2 NIC card one I have disable in and second is active. The problem is in a day some time its ip conflict with other and when I see the event log and get the conflict ip mac and scan it with LAN scanner on one is there for that mac address nic in my network I have disable dhcp also don’t know what is the problem

8 Answers  

---

Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'

1 Answers  

---

What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

2 Answers  

---

Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0

0 Answers  

---