Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

What is the difference between dynamic ip and static ip addressing?

0 Answers  

---

what is the difference between switch and router??

16 Answers   Infosys, Precision Techserve, Thomson,

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

Which ipsec rule is used for the olympia branch and what does it define?

0 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

Explain the terms unicast, multicast, broadcast.

0 Answers  

---

Explain the term 'broadcast'.

0 Answers  

---

What is the difference between RIP & RIPng???? Can anyone explain it..!!! Thank u in advance.

1 Answers  

---

The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM

1 Answers  

---

What is ping utility?

0 Answers  

---

Identify command that configures 'Cisco1' as a secret password? A.) Router(config)# enable secret password Cisco1 B.) Router(config)# enable secret cisco1 C.) Router(config)# enable password Cisco1 D.) Router(config)# enable secret Cisco1

2 Answers  

---