Answer / guest

Answer: C

What is the difference between private ip and public ip?

0 Answers  

---

When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server

3 Answers  

---

Utilizing RIP, what is the limit when it comes to number of hops?

0 Answers  

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers  

---

Which OSI layer performs code conversion, code formatting and encryption? A.) Physical B.) Data-Link C.) Application D.) Transport E.) Presentation F.) Network

1 Answers  

---

in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please

4 Answers  

---

If there is only 2 host in bus topology is that possible collision accord?

0 Answers  

---

Which NetWare protocol works on layer 3--network layer--of the OSI model? A. IPX B. NCP C. SPX D. NetBIOS

1 Answers  

---

The "ipx delay number" command will allow an administrator to change the default settings. What are the default settings? A. For LAN interfaces, one tick; for WAN interfaces, six ticks B. For LAN interfaces, six ticks; for WAN interfaces, one tick C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks D. For LAN interfaces, five ticks; for WAN interfaces, zero Ticks

1 Answers  

---

Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP

1 Answers   CMC,

---

What is difference between switch & hub?

0 Answers  

---

What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth

2 Answers   IBM,

---