Which router command allows you to determine if an IP access list is enabled on a particular interface? A. Router# show ip interface B. Router> show access-list C. Router# show ip access-list D. Router> show interface ip access-list E. Route 1 P.O. box 198

2 Answers  

---

What are the disadvantages of symmetric algorithms?

0 Answers   CCIE,

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

Why Operating System Have only 65,535 port Numbers

5 Answers  

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers  

---

---

A ISDN PRI circuit can be described as which of the following? A.) 24 B channels and 1-64Kbps D channel B.) 23 B channels and 1-64Kbps D channel C.) 2-D channels and 1-C channel D.) 2-64Kbps B channels and 1-16Kbps D channel

1 Answers  

---

What is difference between igp and eigrp?

0 Answers  

---

Station A is transmitting data to station B faster that station B can handle it. When station B's buffer fills up, it send out a message to station A to stop sending data. After B empties out its buffer, station B sends a message to station A to start sending data again. This is most directly an example of (pick the best answer only): A.) Poison Reverse B.) Connectionless protocol C.) Windowing D.) Connection oriented protocol E.) Flow Control F.) Split Horizon

1 Answers  

---

Which protocol switch use for filling its mac-table?

0 Answers  

---

What are the 2 functions of the Data Link Mac layer? A.) Handles access to shared media B.) Manages protocol access to the physical network medium C.) Provides SAPs for higher level protocols D.) Allows multiple devices to uniquely identify one another on the data link layer

1 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

1 Answers  

---

What is segmentation and fragmentation?

0 Answers  

---