Interested to Buy Any Domain ? << Click Here >> for more details...
What is the protocol number for TCP?
A.) 80
B.) 21
C.) 11
D.) 6
- 1 Answers
- 4377 Views
- I also Faced
- E-Mail Answers
Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Console E.) Trace
What command will display all connected OSPFv2 routers?
Which statement is true? A. While bridges are used to segment networks, they will not isolate broadcast or multicast packets. B. A bridge looks at every packet within its network segment and works like a hub re-broadcasting the packet if the destination is within its network segment. C. A bridge maintains a table of the IP addresses of the hosts within its network segment and forwards the packet directly to the destination based upon the IP address. D. A bridge resets the hop count by keeping all packets within the network segment. Only packets addressed to a specific destination host outside the network segment are allowed to pass through the bridge.
Explain what is 5-4-3 rule?
Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0
Which of the following are solutions to the problems encountered with Distance-Vector routing? A.) Defining a Maximum B.) Poison Reverse C.) Triggered Updates D.) Shortest path first algorithm. E.) Split Horizon
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
Where shall i do CCNA cour??. can i do CCNA at home if yes then where shall i get CCNA book or simmulator.or if not then plz reff. me any good center in delhi
Which of the follow do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE
Which of the following statements are true? A.) Store and forward switching creates variable latency through the switch B.) Cut through switching creates variables latency through the switch C.) Cut through switching works at wire speed D.) Store and forward switching works at wire speed
Hi Guys i hv one confusion. Need u peoples help. In EIGRP, maximum hop count is up to 255. By default only 100. Now question is - a) Suppose i hv a network consist of 115 routers & EIGRP routing protocol is configured. By default hop count is 100, so is there any manual configuration necessary for hop count ya router will automatically detect the hop count & will update the hop count accordingly..????? b) In EIGRP, Bandwidth & Delay is used to calculate metric. For this Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0 Now i want, Bandwidth & Load is used to calculate metric. For that wat i hv to configure & wat wub the metric weights. Cud anyone explain it plzzzz..!!!!
Which dynamic type draw back is, if single link down, it removes its routing table?
CCNA 
