Answer / guest

Answer: D

How do you get help on a command after you have received the % incomplete command response from a switch CLI? A. type "history" to review the prompt before the error B. enter a question mark to display all the console commands C. type help followed by the command to see command parameters D. reenter the command followed by a question mark to view keywords

1 Answers  

---

Why Operating System Have only 65,535 port Numbers

5 Answers  

---

Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint

1 Answers  

---

Identify the default serial encapsulation? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP

2 Answers  

---

Where shall i do CCNA cour??. can i do CCNA at home if yes then where shall i get CCNA book or simmulator.or if not then plz reff. me any good center in delhi

1 Answers  

---

What key do you use to view the last command? A.) Ctrl+X B.) Ctrl+Z C.) Ctrl+E D.) Ctrl+P

1 Answers  

---

what is telnet,ssh?? what is the perpose of this? wer r this configured and how to configured??

2 Answers  

---

IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address

2 Answers  

---

What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers   ACS,

---

Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  

---

Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN

1 Answers  

---

What is a switch and why we are using switches?

0 Answers  

---