What is the terminal emulation?

0 Answers  

---

Identify the purpose of the Ping command? A.) Share routing information with a neighbor router B.) Transmit user data when buffers are full C.) Test connectivity at layer 3 D.) Test entire protocol stack

2 Answers  

---

What is the difference between ‘bit rate’ and ‘baud rate’?

0 Answers  

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

2 Answers  

---

The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }

2 Answers  

---

You receive "input filter list is 800 and output filter list is 801" as part of the output from a show interfaces command. What kind of traffic are you filtering? A. IPX/SPX B. TCP/IP C. LocalTalk D. DDR

1 Answers  

---

What does aaa stands for?

0 Answers  

---

The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM

1 Answers  

---

What is icmp protocol?

0 Answers  

---

In which two modes can the ICMP ping command be used? (Choose two) A. user B. privileged C. global configuration D. interface configuration

1 Answers  

---

The CSMA/CD Ethernet IEEE committee is defines as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

1 Answers  

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

1 Answers  

---