When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

Identify the purpose of the Trace command? A.) Explorer packet transmitting routing information B.) Test connectivity C.) Determine the path a packet is taking through the network D.) Transmits user data when buffers are full

2 Answers  

---

Which NetWare protocol provides link-state routing? A. NLSP B. RIP C. SAP D. NCP

1 Answers  

---

Which of the following is a layer 2 device? A.) Switch B.) Router C.) Repeater D.) Hub

4 Answers  

---

Define osi?

0 Answers  

---

What is the IP extended access list range? A.) 1000-1099 B.) 100-199 C.) 1-99 D.) 101-200

4 Answers  

---

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 Answers  

---

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

4 Answers   TCP,

---

What is the Between Normal Switch and Manageable Switch?

15 Answers  

---

what is the concept of HA and FA in VPN tunneling?

0 Answers   CCIE,

---

What is the most common layer 2 device? A. Hub B. Bridge C. Switch D. Router

20 Answers   IBM,

---