I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?

4 Answers   IBM,

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

what is full form of rst,smtps & http?

2 Answers   HCL,

---

What is the Difference between Hub and Switch?

2 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards

1 Answers  

---

How is rip different from igrp?

0 Answers  

---

Which of the following is an example of a Transport Layer protocol? Ethernet IP TCP RS-232

2 Answers  

---

in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks

1 Answers  

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

1 Answers  

---

Which of the follow do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE

1 Answers  

---

Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Automous system number E.) Link state

1 Answers  

---