Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

Which statement is true regarding the user exec and privileged exec mode? A.) The '?' only works in Privileged exec B.) They are identical C.) They both require the enable password D.) User exec is a subset of the privileged exec

1 Answers  

---

what is ACLs? what is the reasons to create ACLs?

1 Answers  

---

hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha

0 Answers  

---

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Which statement is true regarding the user exec and privileged exec mode? A.) The '?' only works in Privileged exec B.) Privileged exec is a subset of the user exec mode C.) They both require the enable password D.) User exec is a subset of the privileged exec mode

1 Answers  

---

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

What hppends when ping 127.0.0.1 command executes?

10 Answers   CMS, Wipro,

---

heyyy frnds can please me that which institue is good for me in hardware and networking because im coming frm Dubai

3 Answers  

---

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  

---

whats the routing protocol supporting in both juniper , cisco routers.

10 Answers   HCL,

---

What is size of ipv4 mac address?

0 Answers  

---