Answer / jitendera sinha

BGp is a broder gateway protcol and it is used for
comunication with the prtocol which have diffrent atonomush
system numbrer.

example_:
on the internet senario this protocol is used

Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells

3 Answers  

---

Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload

1 Answers  

---

The Integrated Services Digital Network (ISDN) Basic Rate Interface (BRI) provides which of the following? A.) 1.544 Mbps B.) 23B + 1D Channel C.) 24B + 1D Channel D.) 2B + 1D Channel E.) 23B + the Disney Channel

2 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers  

---

what is unike ip address

1 Answers  

---

Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..

6 Answers  

---

What are the protocols that are used by every layer of ip/tcp model?

0 Answers  

---

Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical

4 Answers  

---

Identify the purpose of the Trace command? A.) Explorer packet transmitting routing information B.) Test connectivity C.) Determine the path a packet is taking through the network D.) Transmits user data when buffers are full

2 Answers  

---

What is window in networking terms?

0 Answers  

---

Novell NetWare has an Ethernet frame type called Ethernet_II. What is the matching Cisco command line keyword for this encapsulation method? A.) dix B.) sap C.) arpa D.) gns E.) snap F.) novell-ether

1 Answers  

---

Explain what is formula of hold down time of eigrp protocol?

0 Answers  

---